Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Hi Friends,
I see in help soure have tool attachment for milling.
Please teach me how to use it ? Urgent !
I see document write about it. I don't now how to use ?
http://www.proetutorials.com/tutorials_nc/AngleHeadTutorials.htm
There are several pages in Creo's Help Center on this topic. Have you seen all of the following?
About Tool Attachments:
http://www.ptc.com/cs/help/creo_hc/creo20_hc/pma/nc/About_Tool_Attachments.html?queryId=1490a0565bc
To Create a Tool Attachment:
To Use a Tool Attachment:
http://www.ptc.com/cs/help/creo_hc/creo20_hc/index.jspx?id=To_Use_a_Tool_Attachment10686&action=show
Dear Clint N.Walton,
I have read but do not know how to use it in Creo like?
Can You create video ?
Sorry, I don't have any recording software.
Have you tried following the steps in Help Center? Is there a specific point you are getting caught up on?
First, create the Tool Attachment model:
Next, use the Attachment during sequence creation:
This will automatically create the SET / HOLDER data that will be needed in the CL Output and you POST should take care of the rest. I personally don't work on post processing but that is how I have understood this.
http://www.ptc.com/cs/help/creo_hc/creo20_hc/pma/nc/About_Tool_Attachments.html?queryId=1469225781e
Dear Clint Walton,
Because of my Maintanance that expired, can you send me a copy of material?
Best regards