Hi folks
We are new to using Pro Manufacturing on this site.
When doing a profile turning sequence, we are able to generate the tool
path & spit out a G41 in the CNC code (as we require), when using a tool
nose radius greater than 2 mm.
However, when we use a nose radius of 0.4mm, the tool path fails.
Can any of you out there in Pro Manufacturing land shed any light on
this? We would be very grateful.
Thanks
Nash Rodrigues
Manufacturing Engineering Manager
New Castalloy (Plympton)
76-92 Mooringe Avenue
North Plympton
S.A 5037
Australia
PH: +61 8 82925578
FAX:+61 8 82938888
#####################################################################################
This e-mail message has been scanned for Viruses and Content and cleared
by NetIQ MailMarshal
#####################################################################################
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
