Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
My programmers use Creo 2 and have Vericut for material removal checking. When we went to Creo 3 (M190) this went away and now it has an internal material removal that doesn't work well for them. Is there anyway to get Vericut to work in Creo 3?
@sstrehlow wrote:
My programmers use Creo 2 and have Vericut for material removal checking. When we went to Creo 3 (M190) this went away and now it has an internal material removal that doesn't work well for them. Is there anyway to get Vericut to work in Creo 3?
Hi,
Vericut is available in Creo 3.0 until M080 version. Starting from M090 it is replaced by ModuleWorks.
1.] you can install M080
2.] you can buy commercial version of Vericut