cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

creo, vericut integration

ptc-5461421
7-Bedrock

creo, vericut integration

i'm little new to creo

so anybody plese explain me how i can integrate vericut into creo 2.0

i have already install both softwears but when i run nc check it gives "Application VERICUT_DLL is not available or supported on this platform."

ACCEPTED SOLUTION

Accepted Solutions

thanks a lot Wheelsofsteel that works!!!!!

View solution in original post

5 REPLIES 5

It sounds like you haven't installed the vericut option.

you need to run the set up disk again but select reconfigure.

when you come to this screen

recon+2.JPG

select the customise option

then you need to search throught the opptions on this screen and selecet the vericut option to install

recon+3.JPG

You need to complete the reconfig process, then you shoul have the Vericut.dll

Peter

thanks a lot Wheelsofsteel that works!!!!!

I'm also having issues with vericut_DLL not available in my own laptop, and I don't know where to get the vericut application to install. Please how can I install the vericut application online in my laptop? Or how can I get the disk to install the vericut application in my laptop. Thank you

What version of Creo are you using? PTC dropped Vericut for Moduleworks.

 

https://community.ptc.com/t5/Additional-Creo-Questions/ModuleWorks-to-replace-Vericut/td-p/169907

Thank you dschenken, the version I am using is Pro Engineer wildfire 5.
Announcements


Top Tags