cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

keeping the tool down

dfarneth
1-Visitor

keeping the tool down



Hi All,

I've had this situation before but I just lived with it. But I'm tired
of it and would like a fix. I use profile sequences a lot and at the end
of a pass the tool always retracts and comes back down. Can anybody tell
me how to keep the tool down in between cuts? I will attach a picture of
the tool path.

Don Farneth

Engineering Associate

COORStEK

North Table Mtn.

Golden, CO.

303-277-4686




This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
5 REPLIES 5

Hi Don,

We also used to experience such problems.. looks like the are inherent of Profile Sequences... so I avoid using them in toolpaths where the problem may arise...

What I do to get rid of this problem is to use Trajectory Milling Sequences with the option CONNECTION_TYPE set as Z_LAST, as you can see in the attached screenshot. Works like a charm!

HTH

Regards,

Daniel Santos - Sr. NC Programmer / CAM Support

Liebherr Aerospace Brasil

Don,



One thing that I have done as a work around with ?Profile? is to lower the
retract plane to the same height as the cut. Then in the customize box I
would add a GoDelta to retract at the end. I have tried to get PTC to get
rid of all the automatic retracts with no luck.



Thanks,



Kent



Kent Hanson

Chief Executive Officer





27011 Washington Blvd

Edwardsburg, MI 49112, USA



T 269.663.5515

<">http://post-pro.com/default.aspx> khanson@post-pro.com

<">http://postpro.web.officelive.com/default.aspx>



_____

Hi All,

Thanks for all the great replies!

I got just what I wanted by using the Custom Trajectory sequence with
parameters.

1.Conection_Type = Simultaneous

2. Cut_Type = Zig_Zag

3. End_Motion = Z_Last

4. Slice_Path_Scan = Slice_By_Slice



I had never used Custom Trajectory like that before.

It never fails when I get stuck with something this community comes
through!

Thanks again for all your ideas.



Don


A couple more things when using that sequence and those parameter. I like to use "Simultaneous" for the CONNECTION_TYPE so the tool ramps down. If your TRAVERSE_FEED is set to "-" you may get unwanted rapid moves. At least it is this way in WF4 build M070 and has been for a long time.
Terry.

Glad it worked for you Don, 😉

Regards,

Daniel Santos - Sr. NC Programmer / CAM Support

Liebherr Aerospace Brasil

Announcements


Top Tags