Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Hello, everybody,
Does anyone meet the problem when saving the part file to step, the lattice design is missing?
For example, in the first picture, I created a lattice structure, I then saved it as step file.
But when I open the step file, it appeared as the second picture.
Solved! Go to Solution.
@FZ_6577930 wrote:
Hello Martin,
Yes, Creo 8.0.
The lattice is diamond.
I have uploaded the model.
thanks,
Feng
Hi,
Formula driven lattice cannot be exported to STEP.
Please read https://www.ptc.com/en/support/article/cs303867 document.
@FZ_6577930 wrote:
Hello, everybody,
Does anyone meet the problem when saving the part file to step, the lattice design is missing?
For example, in the first picture, I created a lattice structure, I then saved it as step file.
But when I open the step file, it appeared as the second picture.
Hi,
please specify what type of lattice did you create and what Creo version did you use (Creo 8.0.?.0)
... upload your model, if it is possible.
Hello Martin,
Yes, Creo 8.0.
The lattice is diamond.
I have uploaded the model.
thanks,
Feng
@FZ_6577930 wrote:
Hello Martin,
Yes, Creo 8.0.
The lattice is diamond.
I have uploaded the model.
thanks,
Feng
Hi,
Formula driven lattice cannot be exported to STEP.
Please read https://www.ptc.com/en/support/article/cs303867 document.
Ok, got it. It is sad.
However, it can be exported to stl., not so convinient as to step file though.
Thanks for your information.