Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
@岩茉_9843933 wrote:
I am using Creo Parametric 5.0 5.0.4.0
I'm trying to remove material ina rotating sketch.
Applies at 4 microns, but not at 3 microns.
I don't know the cause.
Is there a way to define it below 3 microns?
Hi,
I guess it is accuracy problem. Set absolute accuracy and lower its value.