when I only output Tapping sequnce's Gpost I want add the code M29 instead of M3 code.

[hakdemir]

I am using Creo Parametric Release 8.0 and Datecode8.0.6.0

Hello,

when I only output Tapping sequnce's Gpost I want add the code M29 instead of M3 code.

How can I do it.

Thank you

[Mahesh_Sharma · Accepted solution]

Hi @hakdemir,

Change in code M29 instead of M3 code may need changes at post level. 

There is pretty old document at https://support.ptc.com/appserver/cs/view/solution.jsp?n=115106 regrading the same. This may provide some information. 

Example in article s only for reference. make sure you are thoroughly testing the suggestion prior implementing in production.  PTC does not take any responsibility if something goes wrong on your machine while using this post processor file. You can treat this as an example and then ensure to modify or create a correct post processor that works fine on your machine. Please do not use this example directly.

Thanks