Dear Pro/Gurus I need your expert help.
Gpost forces tool length offset number (G43.4) along with (H) register
to be output with the next Z value.
Is there a fill routine that reads the tool number (LOADTLl / 1) put it
together with spindle command
composing the following format?
G43.4 H1 S1100 M3
Or it can be output right after the spindle command.
S1100 M3
G43.4 H1
Before
T1
M6
G091 G28 Z0.0
G090
G54
G0X0.0Y0.0C0.0B0.0
S1100M3
G1G94G43.4X241.131Y0.0Z-66.0C0.0F9999H1M8B90.0
X162.0
X158.0F100
X241.131F9999
After
T1
M6
G091 G28 Z0.0
G090
G54
G0X0.0Y0.0C0.0B0.0
G43.4H1S1100M3
G1G94X241.131Y0.0Z-66.0C0.0F9999M8B90.0
X162.0
X158.0F100
X241.131F9999
NCL FILE
$$* Pro/CLfile
$$-> MFGNO / T15_MFG
PARTNO / T15_MFG
$$-> FEATNO / 148
MACHIN / UNCX01, 32
$$-> CUTCOM_GEOMETRY_TYPE / OUTPUT_ON_CENTER
UNITS / MM
LOADTL / 1 $$-> CENTER DRILL 6MM 90DEG
$$-> CUTTER / 6.000000
SET / OFSETL, 54
$$-> CSYS / 1.0000000000, 0.0000000000, 0.0000000000, 0.0000000000, $
0.0000000000, 1.0000000000, 0.0000000000, 0.0000000000, $
0.0000000000, 0.0000000000, 1.0000000000, 0.0000000000
MULTAX / ON
INSERT/G0 X0.0 Y0.0 C0.0 B0.0$
SPINDL / RPM, 1100.000000, CLW
COOLNT / ON
FEDRAT / 9999.000000, MMPM
GOTO / 241.1307, 0.0000, -66.0000, $
1.00000000, 0.00000000, 0.00000000
GOTO / 162.0000, 0.0000, -66.0000, $
1.00000000, 0.00000000, 0.00000000
FEDRAT / 100.000000, MMPM
GOTO / 158.0000, 0.0000, -66.0000, $
1.00000000, 0.00000000, 0.00000000
T.I.A
Georgios Lambouras
C.N.C programmer
_____
