Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Can I import a CREO Model into Mathcad directly; and, if so, how can Mathcad help us to improve our design?
Hi,
opposite is possible, this means you can embed MATHCAD Prime 3.1 calculation into Creo 3.0 model.
For example, see Engineering Notebook Powered by PTC Mathcad - YouTube video.
MH
Please check the following videos:
"Creo Parametric 2.0 integration with Mathcad Prime 3.0": https://community.ptc.com/t5/PTC-Mathcad-Tips/Creo-Parametric-2-0-integration-with-Mathcad-Prime-3-0/m-p/439598
"Creo Parametric and Mathcad Prime 1.0 Integration (Transmission Shaft)":
https://community.ptc.com/t5/3D-Part-Assembly-Design/Creo-Parametric-and-Mathcad-Prime-1-0-Integration-Transmission/m-p/439613
And here at "PTC University Learning Exchange": Searching for 'integration'
Thank you Martin Hanak and Vladimir Nosov
David, were these videos helpful to you?
Best,
Toby
