Shear and moment diagram in Mathcad
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Shear and moment diagram in Mathcad
Hi
I have this beam that i have i shared in two sections. I have determined the equations for normal, shear and moment. Now I want to draw them in Mathcad but I don't understand how to do it. I have watched some videos in youtube but it didn't help so much.
I use Mathcad 15.
I really hope you can help me!
Thanks in advance!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I can see I have calculated some thing wrongs.. the update is coming
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Your beam does not appear to be in static equilibrium; where are your constraints?
A simple example:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi Fred,
Thanks for your answer!
There is only one support on my beam and that is placed at left side, Cx, Cy. From point C to FAB there is 600 mm, and the totale length of the beam is 1634,3 mm. At the end of hte right side there is a force F=1502,46 N
Was it what you mean with constraints or?
Thanks i advance!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
This is how I would approach it, assuming a cantilever beam at the left end:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
so-3 schrieb:
Was it what you mean with constraints or?
Fred thought the bearer was not in a static balance.
Your problem seems to be the plotting of the moments and the transverse forces, which has nothing to do with static equilibrium.
Of course, a carrier should be in static equilibrium.
Your carrier is not statically determined according to the sketch. There are missing bearings.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Her is the edited version:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
There are countless worksheets on the topic you are asking for. Try doing a search by writing in the box shown here, what you are looking for:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
The most of the Work sheets/files are created with other programs, I only use Mathcad 15.. so can't open them.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Do research only in the mathcad worksheets:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi so-3,
This is the short way to demonstrate plots in MC15.
Hope the attached File will help you for the first steps with plotting M(x) and FQ(X).
It's really easy to do for you.
Best regards, Volker