Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
I'm using MathCAD 9.0.0.0
If ...
...and...
...then why does...
...when it should clearly be "50" layers in the base?
My program is attached.
Thank you,
Brent
Solved! Go to Solution.
Never mind. I figured it out. I had 2 values for Tb.
Never mind. I figured it out. I had 2 values for Tb.
🙂
Using T to denote both thickness and time may not have been the best idea. You probably confused yourself by doing that.