Xeon or i7 (Trying to decide today!)
‎Dec 05, 2017
09:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 05, 2017
09:09 AM
Xeon or i7 (Trying to decide today!)
Building a new Dell 7720 laptop to run everything from modeling, Mold Analysis, MathCAD, Bunkspeed, Keyshot etc.
Already getting the NVidia M5000M GPU.
1. With Creo 4 starting to support multithreading is it now finally faster to go with Xeon?
2. Since I'll be turning off the onboard GPU that isn't a deciding factor for a CPU
3. Which do you guys recommend?? Leaning toward the E3-1535M V6 for the fastest clock.
Thanks!!!
2 REPLIES 2
‎Dec 22, 2017
11:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 22, 2017
11:26 PM
Go with Xeon.
‎Dec 23, 2017
01:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 23, 2017
01:54 AM
I went Xeon / ECC for reliability only. Always been a good choice with PTC S/W.
Raw performance would dictate otherwise.