The PTC Community email address has changed to firstname.lastname@example.org. Learn more.
Building a new Dell 7720 laptop to run everything from modeling, Mold Analysis, MathCAD, Bunkspeed, Keyshot etc.
Already getting the NVidia M5000M GPU.
1. With Creo 4 starting to support multithreading is it now finally faster to go with Xeon?
2. Since I'll be turning off the onboard GPU that isn't a deciding factor for a CPU
3. Which do you guys recommend?? Leaning toward the E3-1535M V6 for the fastest clock.
Go with Xeon.
I went Xeon / ECC for reliability only. Always been a good choice with PTC S/W.
Raw performance would dictate otherwise.