cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can change your system assigned username to something more personal in your community settings. X

How to display bounding box in thingworx mashup ?

PB_9761313
6-Contributor

How to display bounding box in thingworx mashup ?

In Creo, a bounding box shows minimal box size in which you could put your components, models, or assemblies.
The box shows the limit in the X, Y, and Z-axis.

we can see the bounding box in creo view. Please check the attached screenshot of the bounding box with X, Y and Z-axis in creo view.

Is there any way to see these bounding boxes in thingworx mashup?

i have checked thingview widget but could not find any properties in thingview widget where we can set the values of boxes.

1 ACCEPTED SOLUTION

Accepted Solutions

Displaying a bounding box along with its coordinates (x-axis, y-axis, z-axis) isn't feasible with the current version of ThingView widget. 

However, there is a widget property "Gnomon" which would highlight the axis

View solution in original post

2 REPLIES 2

Hi @PB_9761313,

 

I have noticed that this request is being addressed in the context of a support case. I have asked the engineer in charge to post the solution here once investigation is complete.

Any ideas/suggestions are however still welcome in this thread.

Displaying a bounding box along with its coordinates (x-axis, y-axis, z-axis) isn't feasible with the current version of ThingView widget. 

However, there is a widget property "Gnomon" which would highlight the axis

Top Tags