cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

I installed as per guideline which is provided in site but also Creo parametric is not opening.

Highlighted

I installed as per guideline which is provided in site but also Creo parametric is not opening.

It is showing this error at a time of opening creo parametric:- "Creo parametric Student Edition (for education use only) is sutting down because it could not run the Quality agent, which is required in this edition." and also showing "Creo angent did not initialize correctly"
4 REPLIES 4
Highlighted

Re: I installed as per guideline which is provided in site but also Creo parametric is not opening.


@PA_9623813 wrote:
It is showing this error at a time of opening creo parametric:- "Creo parametric Student Edition (for education use only) is sutting down because it could not run the Quality agent, which is required in this edition." and also showing "Creo angent did not initialize correctly"

Hi,

try following:

  • uninstall PTC Quality agent
  • reboot PC
  • install PTC Quality agent using <INSTALL_PACKAGE>\install\addon\qualityagent_64.msi

 


Martin Hanák
Highlighted

Re: I installed as per guideline which is provided in site but also Creo parametric is not opening.

I followed step is given by you in earlier email about Unistall
PTCqualityagent file and install another Qualityagent file after reeboot
but also this type of error is coming.

On Sun, Sep 27, 2020 at 12:36 AM ADROJA PUJAN RAJESHBHAI <
17bme006@nirmauni.ac.in> wrote:

>
>
Highlighted

Re: I installed as per guideline which is provided in site but also Creo parametric is not opening.


@PA_9623813 wrote:
I followed step is given by you in earlier email about Unistall
PTCqualityagent file and install another Qualityagent file after reeboot
but also this type of error is coming.

On Sun, Sep 27, 2020 at 12:36 AM ADROJA PUJAN RAJESHBHAI <
17bme006@nirmauni.ac.in> wrote:

>
>

Hi,

please publish picture showing details of your steps. I need to know exactly:

  • what item did you uninstall
  • what package did you install

 


Martin Hanák
Highlighted

Re: I installed as per guideline which is provided in site but also Creo parametric is not opening.

Hi @PA_9623813,

 

You can share snapshots as asked by Martin. Also, you may try disabling anti-virus (if there is any) during re-installation and see if it helps.

 

Regards,

Rahul Ghadge

 

 

Announcements
Welcome to PTC Academic!