cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Sketcher bogging

SOLVED
DB_8929339
Guest

Sketcher bogging

Recently my installation of Creo academic started bogging down when in sketcher. It repaints lines very slowly, and is, in general, so bogged down as to be useless. This may have happened after a Windows update - I'm not sure. I can spin/pan/zoom just fine, which I wouldn't expect if it were an issue with graphics hardware. I upgraded to Creo 7, and the problem persists. I re-installed Windows 10, and then re-installed Creo 7, but the problem is still there.

 

Any suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Sketcher bogging

Hi,

install graphic card drivers downloaded from its manufacturer.


Martin Hanák

View solution in original post

2 REPLIES 2

Re: Sketcher bogging

Hi,

install graphic card drivers downloaded from its manufacturer.


Martin Hanák

View solution in original post

Re: Sketcher bogging

Thanks. That worked . . . eventually. I had to do it a couple of times before it "took." I rolled back the most recent operating system upgrade, re-installed the drivers, then re-installed the upgrade. Somewhere amidst all the flailing about, the problem got corrected.

Announcements
Welcome to PTC Academic!