cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

applying logos to curved surfaces

Visitor

applying logos to curved surfaces

Can anyone tell me how to apply a jpg logo onto a curved or cylindrical surface using ProENGINEER (Wildfire 3). Each time I attempt this the logo is repeated on the opposite side. allant
2 REPLIES 2

RE: applying logos to curved surfaces

Hi Allan, When you place the material on the object, instead of selecting the whole part.....select the single surface. Have you tried this? Mark

applying logos to curved surfaces

I have tried this. But as the curved suface (say a cylinder wall) continues all the way round, the logo repeats itself. Allan
Announcements
Welcome to PTC Academic!