cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

drawing help

Newbie

drawing help

Trying to round extrude 11 to .0625 but it can't and it says: The system could not construct the intersection of the part and feature. Recommended actions: Redefine the feature so that it intersects the part. Please help if you can, thanks
1 REPLY 1

RE: drawing help

Hi Wes, Are you creating this as part of the extrude feature or are you creating a new round feature on the extrude? If you are making the fillet in sketcher for the extrude, I would keep it a sharp corner. Making the round as a separate round feature is better design intent. Can you send me the part file to look at? My email address is -. Thanks, Mark
Announcements
Welcome to PTC Academic!