this is the file i downloaded....
I extracted to the desktop. I disabled the firewall and A/V. I ran setup as admin.
I receive 2 errors that both read ......
"The Procedure entry point ?in@?$codecvt@DHH@std@@QBEHAAHPBD1AAPBDPAD3AAPAD@Z could not be located in the dynamic link library C:\Users\Ryan\Desktop\cad\pim\i486_nt\baselibmt.dll"
Windows 8. 64 bit.
This issue is observed while installing Creo 3.0 in some cases and is being reported to R&D. The current available workaround is as mentioned below:
Technical Support Engineer T 800.477.6435 (U.S) E - PTC.com