Post Flooding?

[Dale_Rosema]

I tried to post a new idea to the Creo Cad board and received this error message:

This is the first Idea post I have done in a long time.

[Dale_Rosema]

After I waited 3600 seconds I got this:

It then kicked me out and I have to start again.

[AndrewK]

Hi @Dale_Rosema,

I'm guessing that is related to something I've been doing today. We are archiving some ideas on that board which posts a duplicate message for each archived idea. That must have triggered the post flooding message. 

The second message is something I usually see if I am logged out or switched accounts and try to do something that requires authentication on an old tab. I suspect your session timed out and you were logged out when you tried to post again.

[Dale_Rosema]

I am still logged in, but I waited the 3600 second before trying to post and maybe that is timing out the form filled out for the new post.

[Dale_Rosema]

Got the same error after starting from scratch.

This time I saved the body of the post in case I get booted again.

I do not see any "Highlighted errors" either

[Dale_Rosema]

This morning it failed but only posted the "correct highlighted errors and try again", but there weren't any.

Next attempt it gave me the "Post Flooding" error.

[AndrewK]

Hi @Dale_Rosema This is happening on the Creo Parametric Ideas board? Creo Parametric Ideas - PTC Community I will look into this further and let you know what I find out.

[AndrewK]

Hi Dale, there was an idea saved in your drafts for Creo Parametric Ideas that I was able to post for you. It looks like there was something strange happening with an image that I need to look into a little further. That was probably causing your initial error. Here is the idea Highlight Top / Side Cell Headers in Family Table - PTC Community Is that the correct one? If so, you should be able to edit it if there are any changes you need to make.

[Dale_Rosema]

I edited it to add the second image.