cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

CREO Simulate 7.0

RN_10004064
4-Participant

CREO Simulate 7.0

Hello,

 

I had created profiles using the Bosch Profiles in creo 7.0 and then i am simulating it in creo simulate 7.0 but i found some errors. could anyone please help me.

1 ACCEPTED SOLUTION

Accepted Solutions

Here's the article - "Mesh creation in Creo Simulate fails with message: "AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces" ": https://www.ptc.com/en/support/article/CS115533

View solution in original post

2 REPLIES 2

Here's the article - "Mesh creation in Creo Simulate fails with message: "AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces" ": https://www.ptc.com/en/support/article/CS115533

RN_10004064
4-Participant
(To:VladimirN)

This solved me from error by using contat Interferances