Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
I have just installed the SW "PTC Creo 4.0 Academic Edition".
When launching Creo Parametric, I am getting following error "License request failed for feature".
Can someone help me?
Thanks,
Francesco Scorcelletti
@FS_9742855 wrote:
Hi,
I have just installed the SW "PTC Creo 4.0 Academic Edition".
When launching Creo Parametric, I am getting following error "License request failed for feature".
Can someone help me?
Thanks,
Francesco Scorcelletti
Hi,
license file mentioned on the picture contains license which enables to launch Creo up to release 4.0. The error messages probably informs you that you are trying to launch higher release, i.e. Creo 5.0, 6.0 or 7.0.