cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Modelling a suction cup

Go to solution
ptc-6687916
1-Visitor
1-Visitor
‎Oct 10, 2014 04:02 PM
‎Oct 10, 2014 04:02 PM

Modelling a suction cup

Is is possible in Creo Parametric to motion model the flexible part of a suction cup?

Thanks in advance.

Steve

0 Kudos
Notify Moderator
ACCEPTED SOLUTION

Accepted Solutions
tbrotherhood
12-Amethyst
12-Amethyst
(To:ptc-6687916)
‎Oct 12, 2014 02:24 PM
‎Oct 12, 2014 02:24 PM

Steve,

Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.

Up.PNG

Down.PNG

Model attached.

View solution in original post

suction_cup.prt.18.zip
0 Kudos
Notify Moderator
1 REPLY 1
tbrotherhood
12-Amethyst
12-Amethyst
(To:ptc-6687916)
‎Oct 12, 2014 02:24 PM
‎Oct 12, 2014 02:24 PM

Steve,

Is this what you are after? The offset of DTM1 controls the 'squash' of the cup shown below as a section.

Up.PNG

Down.PNG

Model attached.

suction_cup.prt.18.zip
0 Kudos
Notify Moderator
Announcements
Contact Community Management
Top Tags