My student edition of Wildfire 4.0 has stopped working on my Windows 10 laptop. eSupport opened a file to help me even though Wildfire is no longer supported. I was given Creo 3.0 , but I can not do setup. License problem, perhaps. Help?
Nov 10, 2016
08:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 10, 2016
08:50 PM
My student edition of Wildfire 4.0 has stopped working on my Windows 10 laptop. eSupport opened a file to help me even though Wildfire is no longer supported. I was given Creo 3.0 , but I can not do setup. License problem, perhaps. Help?
My student edition of Wildfire 4.0 has stopped working on my Windows 10 laptop. eSupport opened a file to help me even though Wildfire is no longer supported. I was given Creo 3.0 , but I can not do setup. License problem, perhaps. Help?
Solved! Go to Solution.
ACCEPTED SOLUTION
Accepted Solutions
Nov 29, 2016
12:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 29, 2016
12:34 PM
You should definitely stop using Wildfire at this point. It is no longer supported by PTC.
3 REPLIES 3
Nov 11, 2016
06:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 11, 2016
06:54 AM
I have moved this to the Academic community to get the right eyes on it.
Best,
Toby
Nov 11, 2016
08:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 11, 2016
08:55 AM
Hi,
if you received license file via email, then use procedure mentioned in Problems during installation of Creo Student Edition page.
MH
Martin Hanák
Nov 29, 2016
12:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 29, 2016
12:34 PM
You should definitely stop using Wildfire at this point. It is no longer supported by PTC.
