cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Want the oppurtunity to discuss enhancements to PTC products? Join a working group! X

Problem with holes and checkmark

ptc-6820907
1-Newbie

Problem with holes and checkmark

I am using Creo 2.0 Parametric for building an FTC robot. I have already designed a wheel but when I put in the center axle hole the check mark is grey and won't let me apply the changes. Any suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions
sm
1-Newbie
1-Newbie
(To:ptc-6820907)

When placing a hole at the center of another round object, I like to reference the axis of the existing round object and the plane where the hole starts. Define depth as needed and you should be good-to-go.

View solution in original post

2 REPLIES 2

Make sure the hoe is properly constrained-- ie, you have the location properly fixed and there aren't any of the green handles floating around.

sm
1-Newbie
1-Newbie
(To:ptc-6820907)

When placing a hole at the center of another round object, I like to reference the axis of the existing round object and the plane where the hole starts. Define depth as needed and you should be good-to-go.

Top Tags