We are trying to export x, y, z coordinates from pro e (wildfire 4.0, School Edition) to use in the Cessna Analysis Program. We searched the help center for pro e and found a suggested technique, we tried it and ran into problems. This is what we did: 1) save our drawing as a IGES file, select Datum Curves and Point only 2) from the command window we renamed the file from iges to pts 3) open a new part page 4) Insert> Model Datum > Point > Offset Coordinate System ... the offset CSys opens 5) change type to Cartesian 6) Click import, open the pts file 7) close information window and click save 😎 save file as a pts, x, y, z data will be in the file Step 6 is where we run into problems. The program will not open the pts file, it tries but no points are imported. Any ideas. Hutchinson Minnesota team
