cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

files not found when running configure.bat and selecting no.4 C:\Program Files\PTC\Creo 2.0\Common Files\M120\creo_standards

grebello
1-Visitor
1-Visitor
‎Dec 13, 2015 08:03 PM
‎Dec 13, 2015 08:03 PM

files not found when running configure.bat and selecting no.4 C:\Program Files\PTC\Creo 2.0\Common Files\M120\creo_standards

Hi when configuring standard and units of measure, I get an error message saying the file(s) cannot be found. This is directly after installing the Academic Edition of Creo 2.0 and running the configure.bat as an admin. I also went back and installed the MKS option after thinking the files may be contained in there.

PTC Creo.png

Cheers

George

Labels:
0 Kudos
Notify Moderator
1 REPLY 1
grebello
1-Visitor
1-Visitor
(To:grebello)
‎Dec 14, 2015 01:09 PM
‎Dec 14, 2015 01:09 PM

Problem resolved - I set the common files folder to full control in security and set my user to full control and the problem was solved.

Regards

George

0 Kudos
Notify Moderator
Announcements
Contact Community Management
Top Tags