Can I use Polyroots in a in a loop ?

[remslie]

Hi, I am wishing to solve a Hertzian contact problem for sub-surface stresses for multiple points in order to plot contours. The solution routine uses Polyroots to extract the maximum root for use in the calculation and works fine for a single point. Is it possible to automate the process in a loop for variable x, y and z using Polyroots? I tried a couple of attempts but get errors.

Any assistance would be appreciated.

Thanks Ross

[remslie]

FM,

Thank you so much for your assistance in working on my problem. You have been very generous with your time and have earned a holiday!

Best Wishes

Ross

[-MFra-]

I regret to tell you, but if you are satisfied with the answers, and do not wait others, you should conclude marking an exact answer.

Thank you

With best regards

FM