Get Help

Turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Community
- :
- PTC Mathcad
- :
- PTC Mathcad
- :
- Re: Error- "Too few initial conditions" equations

Options

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

09-06-2018
08:04 AM

09-06-2018
08:04 AM

Error- "Too few initial conditions" equations

The differential equation solve block is giving an error regarding too few initial conditions. I have 3 second order equations and 6 initial conditions. I cannot understand why there is an error??

Any assistance would be appreciated

Thanks Ross

Labels:

4 REPLIES 4

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

09-06-2018
08:42 AM

09-06-2018
08:42 AM

Re: Error- "Too few initial conditions" equations

Mathcad's error messages have always been challenging to understand. An error message in a solve block that can't be traced should usually be interpreted as, "I'm not sure what is the problem but I can't find a solution."

I never found a way to actually parse out what the issue is short of trial and error.

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

09-06-2018
10:44 AM

09-06-2018
10:44 AM

Re: Error- "Too few initial conditions" equations

check the definition of xb, it has a multiply between the name & the bracket

seems to be the only error - after this was corrected the sheet appears to run.

Regards

Andy

Highlighted
##

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

09-06-2018
05:56 PM

09-06-2018
05:56 PM

Re: Error- "Too few initial conditions" equations

Andy,

I knew it had to be something simple. Such a powerful program but so often you get tripped up by simple syntax.The Community saves the day..........again!

Many thanks. Ross

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

09-06-2018
06:00 PM

09-06-2018
06:00 PM

Re: Error- "Too few initial conditions" equations

Fred, It amazes me how complex the code must be behind the what you see. The logic needed to investigate issues and give a meaningful error diagnosis must be just as complicated and I guess they dedicate less time to this than we would like. Thanks for your insights.

Cheers

Ross

Top Tags