I'm not good at English.
I set a screw and a nut with Intelligent fastener.
After that, I check global interference.
Displayed the screw and the nut.
I didn't tinker.
Do the nut and the screw had been interference though was why made together?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
