cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Brick Pattern on Cylinder

Newbie

Brick Pattern on Cylinder

Hello,

I am trying to model a chess piece for a project. I have completed all of the components that I want my piece to have, except for a brick pattern cut in around the outside of the center cylinder. I have searched quite a bit on the internet for topics covering this, but all I have found is Solidworks advice. I am using Creo Parametric 3.0.

Any help would be greatly appreciated!

Rook.PNG

1 REPLY 1
Highlighted

Re: Brick Pattern on Cylinder

Just revolve a groove and pattern it vertically; then pattern two offset vertical groove and pattern this radially and vertically.