cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

CREO 3 is running very slowly

ehoffman-3
1-Newbie

CREO 3 is running very slowly

Even though my CPU is running well within range while program is open (rarely over 40-50%), the program is running very slowly. The disk runs high as expected until program is open, then it goes back down to a low percentage of use. I have an i7-5500U @2.4GHz processor with 8GB ram.... any suggestions???

1 ACCEPTED SOLUTION

Accepted Solutions
StephenW
23-Emerald II
(To:ehoffman-3)

Typically its a graphics card issue... Creo 2.0 incredibly slow on Lenovo Y510P

First try updating your graphics card drivers.

2nd try adding the following option to the config.pro  There are specific instructions on how here: Re: Creo 2.0 Parametric Running Slow

graphics  win32_gdi

View solution in original post

2 REPLIES 2
StephenW
23-Emerald II
(To:ehoffman-3)

Typically its a graphics card issue... Creo 2.0 incredibly slow on Lenovo Y510P

First try updating your graphics card drivers.

2nd try adding the following option to the config.pro  There are specific instructions on how here: Re: Creo 2.0 Parametric Running Slow

graphics  win32_gdi

Updated my graphics drivers, soooooooooo smooth! thank you!!!

Top Tags