cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Cannot Unbend or Create Flat Pattern

CJK_Acuity
1-Newbie

Cannot Unbend or Create Flat Pattern

Help please! This model will not flat pattern or unbend. All radii seem to be constant and the part is fairly basic. Can anyone see what the problem is? I'm in creo elements/pro 5.0


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

The problem is in your first two Bend features. The radius cuts slightly into the main bottom surface. You can either adjust the distance or create a Rip inside the Bend features.

I'm on Creo Parametric 2.0 so can only provide screenshot from this release. Note Form features are suppressed due to missing reference models.

cc15948+pic+1.jpg

cc15948+pic+2.jpg

cc15948+pic+3.jpg

cc15948+pic+4.jpg

View solution in original post

4 REPLIES 4

The problem is in your first two Bend features. The radius cuts slightly into the main bottom surface. You can either adjust the distance or create a Rip inside the Bend features.

I'm on Creo Parametric 2.0 so can only provide screenshot from this release. Note Form features are suppressed due to missing reference models.

cc15948+pic+1.jpg

cc15948+pic+2.jpg

cc15948+pic+3.jpg

cc15948+pic+4.jpg

Thank you much!

Your part is actually set to the default relative accuracy of .0012. Changing this to absolute at .0005 will also resolve your model.

Have a look at this discussion: http://communities.ptc.com/message/260507#260507

Default sheetmetal part template values are absolute .0005 for inch and 0.0125 for metric.

Remember that you have to enable absolute accuracy in config options or config.pro

enable_absolute_accuracy yes

You can do this option in session.

Also see default_abs_accuracy and accuracy_lower_ bound

Top Tags