cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X

Creo Belts

Umar-Siddique
1-Newbie

Creo Belts

Hi, I was trying to add a belt mechanism in creo. But I cannot seem to select references for the pulley. Please help. I cannot select any surface or edge for the references. I have also tried selecting a belt plane. Please help!

2 REPLIES 2

hi 

can you confirm you look into the help center : http://support.ptc.com/help/archive/creo30/creo_pma/usascii/index.html#page/simulate/mech_des/Belts_Pulleys/ToCreateABeltAndPulleySystem.html

 

how about the learning exchange page? https://learningconnector.ptc.com/content/tut-2848/create-belt-connection

 

Finally you will find some tutorial and examples on youtube.


if this still fails, please file case at support with your PTC account

Hi,

I would like to modelize the mechanism of a system of 1 toothed pulley/2 guidance pulleys/1 toothed belt. But it is not a standard configuration. I would like to realize a linear move of a 3 sliders independantly in a linear guidance. The system looks like that :

 

guidage.jpg

The system is based on this mechanism : 

omega.png

When I put a motor inlet linked to the toothed pulley (the biggest one), I would like that the slider moves. I would like to realize that in the mechanism application in Creo.

The problem is that Creo always recognize a closed belt, but in this case this is not.

I hope I am clear enough. Thanks in advance for your answers

Top Tags