Hi,
I recently switch to CREO from WF5.
I am making cosmetic sketches on a surface of a formed part, but when I flatten the sheetmetal the sketch does not flatten with the material.
This was not a problem in WF5. Is there something I need to enable?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
