cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Cuts and Protrusions Normal to a Surface

Newbie

Cuts and Protrusions Normal to a Surface

I have a case where I need to make a cut or a protrusion on a warped surface
that was created using a variable section sweep. The part is a trapazoidal
shape that follows several curves to be able to fit another part over a
distance. All I have at this point is a plane that goes through the center
of the part along with a datum curve on the surface through the datum plane
and the surface where I need to create the cut. I have created a point along
this curve as the location for the cut or protrusion. Now I am at a loss as
how to create the protrusion or cut normal to the surface at this point.

I am using Pro 2001.

Any suggestions?

Thanks in advance,

Dwayne Quatier
QTech Consulting
Announcements
Business Continuity with Creo: Learn more about it here.