Draft on a helical sweep

[ptc-169947]

Does anyone know if it's possible in Pro to add a draft to a helical sweep? In my case, threads on a molded part? Can't seem to get it to work.

Thanks,
Stefan

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[CM10]

I really don't think draft will work. I had a similar thing I was doing, and had to use a variable section sweep (VSS) to draw the section down. I had only 2 turns to deal with, but on a 6-lobed part. Look up my last thread to see the problems I had and my solution.