cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Fill

michmaju
1-Newbie

Fill

My goal is to generate a DXF of a 2D pattern for laser etching. Our vendor needs the pattern created and filled where etching is required. The pattern outline is no problem but I can't figure out how the fill the areas to be etched. Anyone know how to do this in ProE?

WF2

Matthew




This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
glanz
1-Newbie
(To:michmaju)

You are going to have to trick Proe to do this. Take the 2D sketch in Proe and make it a solid 1mm thick or so. Now offset a plane half the thickness so you can make a cross section. Place the section on a drawing sheet and set the cross hatch to around .005 inch or whatever prints out solid, depends on line thickness settings in your print config file. Now you have a filled 2d you export to dxf.
Top Tags