Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
I don't know how to use this board.
I want to see only contents about Creo Elements/Direct Modeling and Model Manager.
Teach me how to display only them.
Solved! Go to Solution.
There is a reorganization in the works to correct this, but for now filtering by label is your best bet.
View solution in original post
The previous board content was reorganized so that specific subgroups no longer exist.
You can also use a filter such as:
https://community.ptc.com/t5/forums/filteredbylabelpage/board-id/CreoModeling/label-name/direct
Thank you, Doug.
I will use the method you shown for a while.
