cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Insert a profile tolerance frame in note

SOLVED
Highlighted
Participant

Insert a profile tolerance frame in note

Hi,

I would like to know if it is possible to insert a profile tolerance frame in general note where all general technical requirements are listed, which like:

     UNLESS OTHERWISE SPECIFIED

          1. PREPARED IN ACCORDANCE WITH ASME Y14.9-2009

          2. DIGITAL DATA FILE INCLUDES FILLTS,CORNER RADII AND DRAFT

          3. VALUES QUERIED FROM PROE ARE BASIC

                              (here put a profile of surface)

I can insert / create a symbol (like surface finish) in note by &gym(symbol name in ProE lib), however I can not find a geometric tolerance in proe lib( symbol dirctionery). It is also possible to relate a seperated profile tolerance frame with general note but I prefer to directly insert it in note, which is more convenerience for move and edit.

thank you any instruction and have a nice day.

Best regards, Hongjie

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Insert a profile tolerance frame in note

You may want to check out this thread

Tips for text

specifically, page 8

View solution in original post

2 REPLIES 2

Re: Insert a profile tolerance frame in note

You may want to check out this thread

Tips for text

specifically, page 8

View solution in original post

Re: Insert a profile tolerance frame in note

Hi Ron,

Thank you very much to introduce so winderful thread, my problem is solved.

I am reading the thread with big small, all are kindly and good experts. On the other side it is boring job to search and read PTC help center.

Best regards, Hongjie