cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Measure the thickness normal to a point

Highlighted
Newbie

Measure the thickness normal to a point

I have over 30,000 points that I read into a file from these points I need to measure the thickness of a very large complicated part normal to each point. I also need to read out the normal thickness at each point and the location to a spread sheet. Does Creo2 have the capability of doing this and if so how?

2 REPLIES 2

Re: Measure the thickness normal to a point

...pack a lunch.......and a Snicker's bar......

Re: Measure the thickness normal to a point

Take a look at this discussion :http://communities.ptc.com/message/199198#199198

I think that it would be useful for you.

If I were you I would use Rapidform XOV or Geomagic Qualify Probe for this task.

They are perfect for such kind of work.

And Reverse Engineering Extension from PTC is not suitable for inspection.

Announcements
LiveWorx Call For Papers Happening Now!