cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X

Revolute a body between 2 edges!!

ptc-5996109
1-Newbie

Revolute a body between 2 edges!!

Hi,

I have partially constrained a body such that it could only rotate in Z-axis. Now, the body doesn't stop when it hits other body rather it passes through. How could i control this motion? The maximum angle it could possibly rotate is like 60° untill it hits the edge of other component, but it rotates complete 360°. Is it possible to prescribe motion between two edges?

Thanks a lot!!

Best,
Vish.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

This is about Mechanism and you need a kind of interference check, to limit the movement when different parts collide, right?

vzak
6-Contributor
(To:ptc-5996109)

You can use "rotation axis limits" on the pin (or cylinder) joint, and set the stopping surface as you wish.

Another option - much less desired - would be to use Cam with liftoff option between the two surfaces that should not interfere.

Regards

- Vlad

Top Tags