cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Sheetmetal Flat Wall Issues in WF3

Highlighted
Visitor

Sheetmetal Flat Wall Issues in WF3

Sheetmetal users, we recently switched from WF2 to WF3 M080 and are seeing some issues with flat walls at 90 degrees and how the relief notches are represented in WF3. Please see attached .jpg files. Has anyone else experienced this? Parts that were created in WF2 open fine in WF3, WF2-Correct.jpg, however, after a full regeneration the relief changes to WF3-Incorrect.jpg



Thanks,

D.P.

1 REPLY 1
Highlighted

Sheetmetal Flat Wall Issues in WF3

I have struggled with this as well and found out, that it was the inside
bend radius that was screwing it up. A software bug.

Bjarne



"Douglas Purtill" <->
29-11-2007 19:11
Please respond to
"Douglas Purtill" <->


To
-
cc

Subject
[proecad] - Sheetmetal Flat Wall Issues in WF3






Sheetmetal users, we recently switched from WF2 to WF3 M080 and are seeing
some issues with flat walls at 90 degrees and how the relief notches are
represented in WF3. Please see attached .jpg files. Has anyone else
experienced this? Parts that were created in WF2 open fine in WF3,
WF2-Correct.jpg, however, after a full regeneration the relief changes to
WF3-Incorrect.jpg

Thanks,
D.P.
Announcements