cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

'Show Clipped Model as Solid' and 'Capped_clip' not working ...

Highlighted
Regular Member

'Show Clipped Model as Solid' and 'Capped_clip' not working ...

When I turn on a cross-section, some solid models appear as surface models. They appear as 'hollow'.

Nevertheless, 'Show Clipped Model as Solid' is checked on in 'Options', and 'Capped_clip' in config.pro is set to 'yes'....
Any suggestions as to what could be wrong?

( Creo 4.0 )

 

Kind regards

 

 

6 REPLIES 6
Highlighted

Re: 'Show Clipped Model as Solid' and 'Capped_clip' not working ...

When I delete the 'bad' cross sections and create them again, they now look okay as solids.
Apparantly, the option settings are only applied when the cross section is created. The cross sections are not updated when options are changed. Weird, but that is the way it appears to be anyway....

 

Highlighted

Re: 'Show Clipped Model as Solid' and 'Capped_clip' not working ...

I have seen this as well. I think it is a rendering glitch in the graphics. I have found that if I change to wireframe display and then back to shaded display it will render properly. Try it, it should be faster than redefinition of the section.

Highlighted

Re: 'Show Clipped Model as Solid' and 'Capped_clip' not working ...

Thanks for the tip! I will try this if I see this problem again!

Highlighted

Re: 'Show Clipped Model as Solid' and 'Capped_clip' not working ...

Nope, the shaded-to-wireframe and then back doesn't work for me...
I am having a section showing this problem now and changing display mode does not alter anything.
Weird thing is, some parts are shown as solid (yellow part) and some are shown as hollow (grey parts) .....
And the section was displayed fine the other day ......

EddyVE_0-1587374060709.png

 



Highlighted

Re: 'Show Clipped Model as Solid' and 'Capped_clip' not working ...

You said that it was working the other day and maybe this is a silly question but are you certain that those parts are solids? In wireframe are the edges the same as part color? Depending on color settings it could be purple if it is not solid. Next thing I would check is what do you get if you move the section plane slightly, maybe even .005"-.010"? If a section goes through the exact points of a cylindrical surface split then you can get funky section results.

Highlighted

Re: 'Show Clipped Model as Solid' and 'Capped_clip' not working ...

No, you misunderstood. 
What is not working (for me now) is tbraxton's tip of switching display modes from shaded to wireframe and back. That doesn't change anything. Still hollow.
What I meant that worked for me is to delete and redefine the section ...
In fact, I just found out I don't even have to delete the section. I just have to do 'Edit Definition' of the problematic section, do nothing, just hit the green checkmark to exit editing and now the section is back okay .....

 

PS. I designed the part myself, same as always, so I am sure it is a solid ..
Here's what it looks now:

EddyVE_0-1587388798849.png

 

Announcements