cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Square butt weld of pipes

Highlighted
Contributor

Square butt weld of pipes

I have couple of hundred pipes in an assembly that should be welded together using square butt weld. There seems to be a way of adding a "pattern", but this doesn't seem to exist in Creo 4. I can't find the option.

Further more, all welds are of the same type, so all I want to show is the weld number. How do I remove all the other parameters that are shown?

1 REPLY 1
Highlighted

Re: Square butt weld of pipes

not sure how you would pattern a butt weld in an assembly because the weld should be pattern-able.  Works great with spot welds because the weld is linked only to a point that is pattern-able.

Consider uploading your assembly or maybe a screen shot.

Bart Brejcha

Design-engine.com

Announcements