cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Wildfire 5 WELDING

Highlighted
Level 8

Wildfire 5 WELDING

Since there was a question on the exploder today regarding Welding, I figured this is a good time to enlist some input from the user community on the same topic, WELDING.


The Sheetmetal Technical Committee is starting to form a focus group to address some concerns/issues with the Welding Functionality and UI that has been redone in Wildfire 5.

I believe our first priority will be towards the functionality and standard compliance, and then toward the UI makeover.

IF there is anyone that has comments/issues with anything listed below, or if you have any additional input/information , feel free to send me a list and I will make sure it is included in our next Welding meeting:


1. Functionality that is not performing as expected and or document.



2. Functionality that is not in compliance with AWS and/or ISO Standards (including welds that cannot be created in accordance with either standard).



3. Anything and everything about the Welding UI, whether it is related to the dashboard/ribbon or the actual weld symbol (3D and 2D).


NOTE: ONLY Comments on Wildfire 5 (& up) will be considered since that is where all the overhaul was done.


Thanks for time/help


Joel Nelson
PTC/USER Sheetmetal TC Chair

[cid:image001.jpg@01CB148F.BE7C3100]