1 Reply 1500 Views
Hello,When working in Piping driven by specifications, to change the tube size, two main steps shoul...
Come on PTC. How many years do we need to endure the Edge Display>Erase Line and the lines do not di...
Hello, I have an optimized geometry that I imported from a FE solver as independent surfaces. I am w...
Does anyone have success with running Creo Parametric 2 or 3 on a browser other than IE ?
1 Reply 1031 Views
Today’s “Fast Facts!” post covers top down design for skeleton models. This content is intended to p...
by AntonioVillanue on 05-03-2018 08:04 AM
0 Replies 1151 Views
So, PTC/User boards are alive with talk about Creo. I finally was able to watch the replay last nigh...
I have a sketch section that consists of several segments. I used the copy curve command, with appro...
3 Replies 757 Views
Hello, I am making perforations in one piece, these perforations are made taking as a reference a fa...
Likes:1. I like that the option for shading with lines (like SW) exists.2. I like some of the new sk...
Where do Creo fonts reside and how do I add more fonts for drawings and for datum sketches.
I'm looking for a away to automatically record the number bends on a sheetmetal part with the intent...
how to Modelling a 'Canted' spring in Creo 2.0
I have this catalog and the *.prt files from PTV dated in the 1990's Is their a tooling library for ...
Hello, Having problem figuring out how to make curved angle extrude, so the edge of extruded cuve st...
11 Replies 6682 Views
Ok...I thought I could do this, but I keep getting two holes in the center.I've created the center h...
Hello, I've been drawing in Creo and I've always had the drill reference axes. However this does not...
I'm trying to set up some PCF's to print from. I've been able to print from the command line success...
Hiiam using creo 1.0 . I create a casting and machining models using family table. I will try merge/...
2 Replies 514 Views
I’m dead in the water until this is fixed. I got a part from our anayst that was previously analyzed...
5 Replies 890 Views
Hi, Is there a reason for which, in my case, the interval of variable "t" in curve from equation has...
5 Replies 997 Views
I'm trying to create a Spot Weld in CREO 2.0. I've created the Datum Point... but I can't select it ...
16 Replies 1432 Views
Hi, Is there an easy way to create a curve of the unwraped cut with an oblique line in a cylinder? I...
by jlee-10-11-12 on 12-07-2018 02:57 PM
0 Replies 300 Views
Hello,When i try to do practise in Creo Parametric Tolerance Analysis CircuitCard Project, i find th...
2 Replies 657 Views
Need a little bit of jovialness today. Need to vent. Join the group (or just visit) - The PTCooler h...
Hi All, I am beginner to Pro program looking for some initial level exploration. Can you please guid...
8 Replies 1118 Views
Dear Expertes, As you can see the below image. Is there any way i can control the pattern so that th...
by jlee-10-11-12 on 12-07-2018 02:58 PM
0 Replies 215 Views
Hello,Why i have a small red question mark above Constraint in measure difinition's name column of C...