On a sheet metal drawing, there are holes and slot hole. I found that Creo did not recognize the cen...
Hello, I am trying to model something similar to the pictures attached where it is an aerofoil with ...
I’m working a repeat region. I'd like to modify how &rpt.index reports.I’d like my index to read 10,...
3 Replies 533 Views
How do I connect a spline, arc or line on the right datum plane to sketch on the top plane to make a...
OK, I got it to work. Turns out I was doing all the right things, except for one. The following appl...
after open .stp file in creo i cant edit part file please help me. thanks
3 Replies 482 Views
Please advise on the short cut key on the modeling.
2 Replies 700 Views
Hi,I came across following article about command-line parameters that ProductView Adapters executes ...
3 Replies 329 Views
I made sheetmatal model using extrude without "add bends on sharp edge"And added round at edge with ...
Hello,I get the type and id of the analysis feature using the ProAnalysisTypeGet API and now I want ...
hi, I am trying to visit the individual values of analysis type feature, but I am only able to reach...
I did this years ago in Wildfire and sheetmetal did not know how to flatten it, but it was good enou...
Sometimes we have situation when we need to make relation with parameters which have long fixed name...
1.what is the difference between name and common name? 2.what is standard and default orientation?
our office has not plm. we work with search path..ma we have lots of directories and files to load i...
Using Creo 3/Simulate. Modeled a circular flange and am trying to use stress linearization (SL) to e...
HiI have some problems with drawing environment for exporting the sheets.I know about drawing settin...
Rename in assembly!
Hello All, My group recently purchased a new display for meeting use and it has 4k resolution capabi...
by wcheng on 05-03-2018 08:10 AM
0 Replies 206 Views
How to disable the "No Dependency" option for copy geometric in Creo Parametric 3.0I can't choose ot...
Hello everybody, First, excuse me for my bad level in English, I am a French, and for misspellings. ...
Hallo zusammen, Vermißt jemand das Deutsche U/I im Modeling Express 6.0? Habe Info vom Kunden, daß i...
I am trying to make thread on 24 mm shaft, at both ends. Now at one and I sweep cut thread with 3 mm...
Hi,I'm normally found lurking in the Analysis & Simulation forum.I have an import feature I need to ...
Hello All,I am facing issue with cabling parameters updation for connectors.I have a 3 pin connector...
3 Replies 371 Views
To all, I have a situation where I have a sheet metal part with two 90 degree bends (approx. .31 thi...
Hello everyone! I had this example on my test and I was unable to solve it so I came here for a help...
1 Reply 264 Views
Hello to all,I need to form a sheet metal jacket for a water heater that has a lap side seam, but it...
Hiusing CREO 2 :how to create a layer with a specific rule for Datum Axis defined as Reference ?Just...