cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X

setting diameter dimension while drawing the circle

ClemensNader
6-Contributor

setting diameter dimension while drawing the circle

I hope i can explain it well that everbody is unterstanding my problem.

So when i used Creo Parametric 1.0 it was a default setting or just normal when i was drawing a circle in a sketch that it automatically shows while going from small to big with the circle with the mouse to type already the dimension i want.

Now on 6.0 i have to click on the circle symbol place it on the layer and then i can change it?

Is it somehow possible to change that f.e. with a config setting or do i have to accept it and live with that.

2 REPLIES 2

Hello everyone,

 

Since the thread linked about has an accepted solution, I will go ahead and close this duplicate.

 

PTCModerator

Top Tags